It is a siloxane-based, ready-to-use, transparent insulation product that makes it waterproof by preserving its naturalness without forming a film layer on the absorbent surfaces on the exterior where it is applied. It does not prevent the breathing capacity of the building or the stone, it does not distort its appearance. Owing to its high alkali resistance it can be applied easily to new or old concrete. It prevents salt efflorescence and staining caused by the lower surface. Protects the building against damage and corrosion from rainfall. It extends the life of the structures.
Surface Preparation&Application
The surfaces must be clean, smooth, solid and cleaned from all kinds of dust, oil, dirt, rust, mold oil, detergents and wastes that prevent adhesion. If segregation occurs in concrete, damaged and loose parts should be discarded and weak parts removed. If there are cracks or cavities on the floor or wall where the application will be done, they must be repaired using EXELANS ENERGY REPAIR MORTAR. PROF W-TE application should be started after 3-4 days. The surface on which PROF W-TE will be applied must be dry. PROF W-TE is ready-to-use. It should be mixed for a minimum of 3 minutes with a low speed mixer in a clean container or in its own package. No water should be added in any way. For maximum penetration when applying the first layer, it must be applied to dry surfaces with a suitable roller, brush or sprayer. The second layer must be applied about 4 hours later. Three layers may be required on very porous surfaces to provide maximum protection.